*GHETTOBLASTER » 27 May 2025, 8:16 am » wrote: ↑
There is 1 sensor that a dealership mechanic can't get to without pulling the engine.
It's a crank position sensor that reads magnetic pulses off the flywheel
It sits close to the floor pan and about a foot from the gas pedal.
The labor cost to change out this sensor exceeds the value of the car in many cases.
The mechanic was nice enough to mention "off the record" that if I was to slit the carpet and cut open the floor right where he drew an X....that changing out that sensor was pretty easy,
He was right..!!
From that day on I forced myself to learn about those systems and do all my own work on computer controlled vehicles.
BTW...my Jeep's exhaust manifold [actually a low grade stainless steel tubular header] was cracked and was easy to MIG weld.
I removed the cat converter and replaced it with $2 worth of straight pipe....
Today my Jeeps sits at 417,000 miles and counting.....

417K is highly respectable! So, your jeep has a 4.0? Must be an older Jeep with the inline 6. But, it can't be that old if it has a crank position sensor. Why would it even need a crack position sensor? I could understand a cam position sensor - heck, they probably work together to electronically adjust timing. Wish I had even known about that - could probably fix that one myself.
The exhaust manifolds on the 3.8 are cast parts. They are known to crack - likely a wear item. I hate working on exhausts, especially old ones. All the hardware is usually rusted and fused on - need a torch to get it a part. That's where my tinkering ends and my wallet opening up begins.