User avatar
*GHETTO BLASTER
27 May 2025 9:21 am
User avatar
      
17,379 posts
Skans » 27 May 2025, 8:52 am » wrote: ↑ 417K is highly respectable!  So, your jeep has a 4.0?  Must be an older Jeep with the inline 6.  But, it can't be that old if it has a crank position sensor.  Why would it even need a crack position sensor?  I could understand a cam position sensor - heck, they probably work together to electronically adjust timing.  Wish I had even known about that - could probably fix that one myself.

The exhaust manifolds on the 3.8 are cast parts. They are known to crack - likely a wear item.  I hate working on exhausts, especially old ones.  All the hardware is usually rusted and fused on - need a torch to get it a part.  That's where my tinkering ends and my wallet opening up begins.
Mine's a 1993.
The 4.0 Jeep engine  is a re-incarnated Rambler / AMC 258 engine that dates back to 1964.
[If I was a more dedicated  SHTF Prepper, I would scrounge up all the parts to convert my 4.0 to a one barrel carburetor and single point, non electronic ignition.... 8-)]   

About the CPS...the most accurate way to divide a circle into equal parts is to start with the largest circle you can.
This is what makes the flywheel the best choice to use as a reference.
Yep, it's always a Crap Shoot when you're working with rusty nuts & bolts.
That's when you get out the ox-acetylene torch and a can of PB RUST BLASTER to heat and marinate the rusty parts into submission.... :twisted:  
 
Updated 1 minute ago
© 2012-2026 Liberal Forum

Search