User avatar
Deezer Shoove
7 Jul 2022 9:48 pm
User avatar
Senior Moderator
Senior Moderator
10,444 posts
GHETTOBLASTER » 07 Jul 2022, 6:55 pm » wrote: ↑ How did our "Slow foot drag to Metric" harmed the auto inductry...?
Machinists have used a decimal based INCH SYSTEM since the very beginning of time.
AFAIK it was good enough to get us to the Moon and back.
The switch to metric is a prime example of how [[[Globalism]]] was shoved down our throats at our own expense.
It made our standard tooling that was more than adequate to show the rest of the world how stuff gets done....nearly obsolete.
It made a mess out of sorting out our national  auto parts supply system.
You are mixing up what I said a little bit.
I mentioned it parenthetically to say we haven't adopted the metric system here.
And part of what helped stop that was automotive factors.
People that build them and people that drive them both contributed to the foot dragging.

The builds are ALL metric these days. I design and launch vehicles. I know.
Tooling is nearly all there. If you look at CADCAM work. Pretty much all metric.
There's still some legacy tooling and parts but that is "catching up".

It all has to do with economics. It's just business to NOT have two sets of tooled parts.
There are also homologation requirements that are easier to certify if everything is metric.

We would end up being the last place on Earth using imperial (English) measurements.
Dual dimensioning went out decades ago. At least in automotive.
Please seat yourself.

Image

I like the very things you hate.
Updated 4 minutes ago
© 2012-2026 Liberal Forum

Search